- out of stock
- out of stock
The Rat Race
Always wanting to expose our society’s incoherence through a cheeky lens, Romain has worked with Kallonji showing us that we are all running after a carrot. Is the race worth it is the question? The Basic UnInc RDM is a supercharged Basic with all the upgrades you want to have on a classic board. It comes in a camber with sintered base and we added some slamback inserts to make it the ultimate all-round board.
All Blem boards are covered by our standard warranty and have never been ridden.
Our boards meet all our technical specs & manufacturing standards.
The goal of the program is to reduce waste as much as possible and avoid putting usable products in the trash.
A Blem board presents only cosmetic blemishes include minor pits, bumps, dimples, die-cut blems, scratches, an edge-to-base gap or a misprinted graphic.
UnderBite edges re-distribute a rider’s weight in such a way that it enhances turning ease and edge hold. Creating divots inward at the binding area reduces and disrupts the surface area of the edge that has contact with the snow while the board is turning. This increases the edge pressure by distributing your weight/energy in the areas where you need it - from the binding out, and through the center of the board where the carving arc is taking place. This segmentation of the sidecut into 3 key zones focuses your body weight onto areas that initiate, hold and release turns.
Creating a lighter, more responsive core than the Full Poplar. The Poplar + Bamboo uses the same durable core, lightens it up by replacing 30% of the Poplar with Paulownia and then inserts two bamboo stringers down the full length for added pop and response
Just like it says. Pellets or course powder is pressed until it forms a solid. There are several suppliers for our entire industry and they each have different codes for them, depending on the color and transparency. These codes can make it seem like you’re getting many different kinds and grades of sintered but they’re all pretty much the same as far as you and I will ever tell. True Sintered is harder and more expensive than extruded and it can be faster for those that ride aggressively fast. But to do that, it needs to be waxed and prepared for local conditions.
|Board Length (cm)||156W|
|Surface Area (dm2)||41,8|
|Tip Length (cm)||21,3|
|Tail Length (cm)||21,3|
|Effective Edge Length (cm)||118,5|
|Contact Length (cm)||113,5|
|Waist Width (cm)||25,9|
|Front Foot Width (cm)||26,7|
|Rear Foot Width (cm)||26,7|
|Tip Width (cm)||30,3|
|Tail Width (cm)||30,3|
|Rocker / Camber (mm)||C0.4|
|Sidecut Radius (m)||8.2 - 7.5 - 8.2|
|Ref. Point (cm)||57,2|
|Ref. Point (in)||22,5|
|Ref. Stance Setback (cm)||0|
|Min Ref. Stance Width (cm)||53,2|
|Min Ref. Stance Width (in)||20,9|
|Max Ref. Stance Width (cm)||61,2|
|Max Ref. Stance Width (in)||24.janv|
|Rider Weight (lbs)||150-200|
|Rider Weight (kg)||68-90|